EPX Plus Mobile Heater Configuration
The EPX Plus mobile heater comes with an in-built CCD 401 and ready to communicate with Avensor. Check the following connections during the initial setup.
| CCD 401 | EXP Controller RS-485-1 |
| A | + |
| B | - |
| GND | GS |
No configurations are needed for the EPX Plus mobile heater. The user must enter the following values while adding the device in the Avensor application.
| Parameter | Value |
| Address | 1 |
| Data bits | 8 |
| Stop bits | 1 |
| Parity | None |
| Baud rate | 38400 |