SENECA Z-D-IN/Z-10-D-IN Configuration

The module must be turned off before it is configured. Configure the communication settings by using the DIP switch.

1. Set the baud

DIP Switch position 1	DIP Switch position 2	Baud
-	-	9600
-	On	19200
On	-	38400
On	On	57600
-	-	EEPROM

 

2. Set the address.

DIP Switch position 3	DIP Switch position 4	DIP Switch position 5	DIP Switch position 6	DIP Switch position 7	DIP Switch position 8	Address
-	-	-	-	-	On	1
-	-	-	-	On	-	2
-	-	-	-	On	On	3
-	-	-	On	-	-	4
-	-	-	-	-	-	---
On	On	On	On	On	On	63
-	-	-	-	-	-	EEPROM

 

3. Set the status of the RS-485 terminator.

DIP Switch position 10	Status
--	Disabled
On	Enabled