MAS 801 Configuration

The unit is connected to this device through the following terminals:

CCD 401	MAS 801
RS-485 A	Modbus A+
RS-485 B	Modbus B+

 

1. Go to Settings 
2. In the Modbus RTU group, set the following parameters:

Parameter	Setting
Enable	Enabled
Baudrate	19200
Parity	None
Stop bits	2

 

3. Click Save.

Note:

• One MAS 801 device must be added in Avensor for each pump.
• The Modbus ID in Avensor must correspond to the Modbus ID in the MAS 801 device.
• The Modbus id mapping group in the MAS 801 device shows the Modbus ID of each pump.